Cerabar S/Deltabar S Description of parameters (FF configuration program)
Endress+Hauser 25
FREE_SPACE
Display
Index: 24
Data type: Float
Access: Read only
Displays in percent the system space available to execute further function blocks.
Input range:
0...100 %
FREE_TIME
Display
Index: 25
Data type: Float
Access: Read only
Displays in percent the free system time available to execute further function blocks.
Input range:
0...100 %
GRANT_DENY
Selection
Index: 14
Data type: DS-70
Access: Auto, OOS
Grant or restrict access rights for a fieldbus host system to the device. This parameter is not
evaluated by Deltabar S and Cerabar S.
HARD_TYPES
Display
Index: 15
Data type: Bit String
Access: Read only
Displays the input signal type for the Analog Input function blocks.
ITK_VER
Display
Index: 41
Data type: Unsigned16
Access: Read only
Displays the revision status of the ITKs (Interoperability Test Kit).
LIM_NOTIFY
Entry
Index: 32
Data type: Unsigned8
Access: Auto, OOS
Enter the maximum possible number of event reports that can be simultaneously present as
unacknowledged. The parameter is not evaluated by Deltabar S and Cerabar S.
MANUFAC_ID
Display
Index: 10
Data type: Unsigned16
Access: Read only
Displays the manufacturer identification number.
Endress+Hauser: 0 x 452B48 (decimal: 4533064)
MAX_NOTIFY
Display
Index: 31
Data type: Unsigned8
Access: Read only
Displays the number of event reports supported by the device that can be simultaneously
present as unacknowledged. → See also this table, LIM_NOTIFY parameter description.
MEMORY_SIZE
Display
Index: 22
Data type: DS-69
Access: Read only
Displays the configuration memory available in kilobyte. This parameter is not supported by
Deltabar S and Cerabar S.
MIN_CYCLE_T
Display
Index: 21
Data type: Unsigned32
Access: Read only
Displays the shortest execution time supported by the device.
Factory setting:
1600
1
/
32
ms (≅ 50 ms)
Resource Block
Parameter Description
To Next Page
Loading...
