Endress+Hauser cerabar S - Page 53

Cerabar S/Deltabar S Description of parameters (FF configuration program)
Endress+Hauser 53
SENSOR_
MEASUREMENT_TYPE/
SENSOR MEAS. TYPE
Display
Index: 17
Data type: Unsigned16
Access: Read only
Displays the sensor type.
• Deltabar S = differential
• Cerabar S with gauge pressure sensors = relative
• Cerabar S with absolute pressure sensors = absolute
SENSOR_MIN_
ABSOLUTE_LIMIT/
Pmin SENS. DAMAGE
Display
Index: 18
Data type: Float
Access: Read only
Displays the minimum permissible absolute pressure of the sensor (vacuum-proofing).
SENSOR_MAX_
ABSOLUTE_LIMIT/
Pmax SENS. DAMAGE
Display
Index: 19
Data type: Float
Access: Read only
Displays the maximum permissible absolute pressure of the sensor (overpressure-proofing).
TEMPERATURE_1_
SENSOR_LIMIT_LOW/
Tmin SENSOR
Display
Index: 20
Data type: Float
Access: Read only
Displays the lower nominal temperature limit of the sensor.
TEMPERATURE_1_
SENSOR_LIMIT_HIGH/
Tmax SENSOR
Display
Index: 21
Data type: Float
Access: Read only
Displays the upper nominal temperature limit of the sensor.
SENSOR_HARDWARE
REVISION/
SENSOR H/WARE REV.
Display
Index: 22
Data type: Unsigned8
Access: Read only
Displays the revision number of the sensor hardware
e.g.: 01.00.00.
Service Transducer Block
Parameter Description