Incoming acceptance and product identification Liquicap M FMI51 HART
12 Endress+Hauser
3 Incoming acceptance and product
identification
3.1 Incoming acceptance
Check whether the packaging or content is damaged. Check that the goods delivered are
complete and compare the scope of delivery with the information in your order.
3.2 Product identification
The measuring device can be identified in the following ways:
• nameplate data
• extended order code with a breakdown of the device features on the delivery note
• the serial number from nameplates in W@M Device Viewer
(www.endress.com/deviceviewer: all of the information on the measuring device is
displayed along with an overview of the scope of the technical documentation provided
• the serial number on the nameplate into the Endress+Hauser Operations App or use the
Endress+Hauser Operations App to scan the 2-D matrix code (QR Code) on the
nameplate
Dat.:
IP66/ IP67
NEMA4X
Order Code.:
Ser.No.:
mm
Output:
L1 =
L3 =
L =
mm
mm
1
2
3
4
5
6
7
9
8
10
11
12
13
14
15
A0040359
1 The Liquicap M nameplate
2 Order number
3 Serial number
4 Electronic insert
5 Electronic insert output value
6 Ambient temperature at housing
7 Max. permissible pressure in tank
8 Safety certificates
9 Functional safety
10 Probe length values
11 ATEX approval
12 WHG approval (German Water Resources Act)
13 Safety information
14 Production date
15 Bar code
3.3 Storage and transport
For storage and transportation, pack the device in such a way as to protect it against
impact. The original packaging offers the best protection for this. The permitted storage
temperature is –50 to +85 °C (–58 to +185 °F) ±5 °C (±8 °F).
To Next Page
Loading...