Endress+Hauser Liquicap M FMI51 HART - Function: Linearization

Liquicap M FMI51 HART Commissioning
Endress+Hauser 57
• function: Linearization
• subfunction: Customer unit
- % (percentage)
- l
- hl
- m
3
- dm
3
- cm
3
- ft
3
- usgal
- igal
- kg
- t
- lb
- ton
- m
3
- ft
3
- mm
- inch
- user-spec.
• subfunction: Customized text
13)
• subfunction: Diameter
14)
- xxxx m
• subfunction: Intermed. height
15)
- xx m
• subfunction: Edit
16)
- Read: Table No.: 1, Input level: x m, Input volume: %
- Manual: Table No.: 1, Input level: x m, Input volume: %
- Semi-automat.: Table No.: 1, Input level: x m, Input volume: %
- Delete
• subfunction: Status table
16)
- Enabled
- Disabled
• subfunction: Max. scale
16)
- 100 %
7.5.1 Function: "Linearization"
Subfunction: "Type"
Select the type of linearization in this subfunction.
Options:
• None
In this type of linearization, the measured level is not converted but instead is output
linearly in the level unit selected →  47.
• Linear
In this type of linearization, the measured value output is linear to the measured level.
13) The function is displayed if the "User-spec." option was selected under the "Customer unit" subfunction.
14) The function is displayed if the "Horizontal cyl" or "Sphere" option was selected under the "Type" subfunction.
15) The function is displayed if the "Pyramid bottom", "Conical bottom" or "Angled bottom" option was selected under the "Type" subfunction.
16) The function is displayed if the "Table" option was selected under the "Type" subfunction