Endress+Hauser Liquicap M FMI51 HART - Page 56

Commissioning Liquicap M FMI51 HART
56 Endress+Hauser
Linearization
• function: Linearization
• subfunction: Type
- None
- Linear
- Horizontal cyl
10)
- Sphere
10)
- Pyramid bottom
11)
- Conical bottom
11)
- Angled bottom
11)
- Table
• subfunction: Mode
- level
- Ullage
• subfunction: Simulation
- Sim. off
- Sim. level
- Sim. volume
• subfunction: Sim. level value or Sim. vol. value
12)
- xx.x%
10) If you enter a value for this function, you must also enter a value for the "Diameter" subfunction in another step.
11) If you enter a value for this function, you must also enter a value for the "Intermed. height" subfunction in another step.
12) The function is displayed if the "Sim. off" option was not selected under the "Simulation" subfunction.