Endress+Hauser Liquicap M FMI51 HART - Mounting and Installation; Quick Installation and Requirements

Liquicap M FMI51 HART Mounting
Endress+Hauser 13
4 Mounting
4.1 Quick installation guide
A probe installation
A0040388
1. Screw the probe onto the proper place.
2. Fasten the probe with proper torque in accordance with the thread size (see table
below).
A
1)
B
2)
G½ < 80 Nm (59.0 lbf ft)
G¾ < 100 Nm (73.7 lbf ft)
G1 < 180 Nm (132.8 lbf ft)
G1½ < 500 Nm (368.7 lbf ft)
1) Thread size
2) Torque
Aligning the housing
1 → 2 → 3
...270°
A0042107 A0042108 A0042109
Tighten the clamping screw with torque < 1 Nm (0.74 lbf ft).