Endress+Hauser Liquicap M FMI51 HART - Error Messages and Parameter Locking

Liquicap M FMI51 HART Operation options
Endress+Hauser 37
A0040582
 15 The marker jumps to the next position.
A0040583
 16 The marker jumps back to the previous position.
A0040584
 17 The current position and all positions to the right are deleted.
Return to the measured value display
Pressing the left and center key simultaneously has the following effect:
• it takes you from the editing mode to the display mode of the functions
• it takes you from the display mode of the functions to the submenu
• it takes you from the submenu to the main menu
• it takes you from the main menu to the measured value display
6.2 Error messages
If the automatic monitoring function of Liquicap M detects an error, the related softkey
symbol appears over the center key.
If the softkey symbol is flashing, only "Warning"-type errors are present.
If the symbol is displayed continuously, at least one "Alarm"-type error is present.
Press the key in the center to display the currently pending errors list.
To find information about the differences between "Alarm" and "Warning" →  76
6.3 Locking and unlocking configuration
6.3.1 Key locking
Press all three keys simultaneously. The device is then locked.
6.3.2 Key unlocking
Press all three keys simultaneously. The device is then unlocked.
6.3.3 Software locking
Locking the device is descripted in "Safety settings" →  52.
In the menu, the current locking status of the device is displayed in the "Status" subfunction
under "Safety settings" SAX01.
The following values can appear: