Endress+Hauser Liquicap M FMI51 HART - Menu-Based Output and Device Properties

Commissioning Liquicap M FMI51 HART
62 Endress+Hauser
Subfunction: "Max. scale"
In this function, specify the maximum contents of the tank in the customer unit.
7.6 Menu: "Output"
You can make the following settings in the "Output" menu:
The factory settings are shown in bold.
Submenu: Extended calibr.
• function: Extended calibr.
• subfunction: Measuring range
- 2 000 pF
- 4 000 pF
• subfunction: Sensor DAT Stat.
- OK
• subfunction: Sensor DAT
- Upload
- Download
• function: Output / Calculat
• subfunction: Curr. turn down
- On
- Off
• subfunction: Turn down 4 mA
17)
- 0%
• subfunction: Turn down 20 mA
17)
- 100%
• subfunction: 4 mA threshold
- On
- Off
Submenu: HART setting
• function: HART setting
• subfunction: HART address
- 0
• subfunction: No. of preambles
- 5
• subfunction: Short TAG HART
- TAG
• subfunction: Output / Calculat
• - Current span
- 4 to 20 mA
- Fix. curr. HART
• subfunction: mA value
18)
- 4 mA
Submenu: Simulation
• function: Simulation
- Off
- On
• function: Simulation value
19)
xx.xx mA
17) This function is only displayed if the "On" option was selected under the "Curr. turn down" subfunction.
18) This function is only displayed if the function value "Fix. curr. HART" was selected under the "Current span" subfunction.
19) This function is only displayed if the "On" option was selected under the "Simulation" function.