Electrical connection Liquicap M FMI51 HART
28 Endress+Hauser
Ex d protection
• aluminum housing F13
• stainless steel housing F27
• aluminum housing T13, with the separate connection compartment
Gas-tight process seal
• aluminum housing F13
• stainless steel housing F27
• aluminum housing T13, with the separate connection compartment
To connect the electronic insert to the power supply:
A0040635
1. Unscrew the housing cover.
2. Remove the housing cover.
3. Release the cable gland.
4. Insert the cable.
Applies to the housing T13.
To connect the electronic insert to the power supply:
To Next Page
Loading...