Endress+Hauser Liquiline CA80SI - Page 56

Operation Liquiline System CA80SI
56 Endress+Hauser
Menu/Setup/General settings/Logbooks
Function Options Info
Data logbook SP1 Assignment to measuring channel
Source of data Read only The assigned measuring channel is displayed
Measuring parameter Read only Plain-text information on the parameter that is
being recorded
Unit Read only Information about the unit in which the data are
available
Logbook name Customized text, 16
characters
Line plotter Menu to define the graphic display
Axes Selection
• Off
• On
Factory setting
On
Should the axes (x, y) be displayed (On) or not
(Off)?
Orientation Selection
• Horizontal
• Vertical
Factory setting
Horizontal
You can choose whether the value curves should
be displayed from left to right (Horizontal) or
from top to bottom (Vertical). If you want to
display two data logbooks simultaneously, make
sure that both logbooks have the same settings
here.
X-Description Selection
• Off
• On
Factory setting
On
‣
Decide whether a description should be
displayed for the axes and whether gridlines
should be shown. In addition, you can also
decide whether pitches should be displayed.
Y-Description
Grids
Pitches
X Pitch/Grid
distance
10 to 50%
Factory setting
10 %
‣
Determine the pitch.
Y Pitch/Grid
distance
Data logbooks For connected Memosens sensors (optional)
New You can create a maximum of 8 data logbooks.
Logbook name Customized text, 20
characters
Source of data Selection
• Sensor inputs
• Controller
• Current inputs
• Temperature
• Fieldbus signals
• Mathematical functions
Factory setting
None
‣
Select a data source for the logbook entries.
You can choose from the following:
• Connected sensors
• Available controllers
• Current inputs
• Fieldbus signals
• Binary input signals
• Mathematical functions
Measured value Selection
depend on Source of data
Factory setting
None
You can record different measured values
depending on the data source.