Endress+Hauser Proline Promass E 300 - Page 107

Proline Promass E 300 PROFINET Commissioning
Endress+Hauser 107
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Minimum frequency value The Frequency option is
selected in the Operating
mode parameter (→  102)
and a process variable is
selected in the Assign
frequency output parameter
(→  106).
Enter minimum frequency. 0.0 to 10 000.0 Hz –
Maximum frequency value The Frequency option is
selected in the Operating
mode parameter (→  102)
and a process variable is
selected in the Assign
frequency output parameter
(→  106).
Enter maximum frequency. 0.0 to 10 000.0 Hz –
Measuring value at minimum
frequency
The Frequency option is
selected in the Operating
mode parameter (→  102)
and a process variable is
selected in the Assign
frequency output parameter
(→  106).
Enter measured value for
minmum frequency.
Signed floating-point
number
Depends on country
and nominal
diameter
Measuring value at maximum
frequency
The Frequency option is
selected in the Operating
mode parameter (→  102)
and a process variable is
selected in the Assign
frequency output parameter
(→  106).
Enter measured value for
maximum frequency.
Signed floating-point
number
Depends on country
and nominal
diameter
Failure mode The Frequency option is
selected in the Operating
mode parameter (→  102)
and a process variable is
selected in the Assign
frequency output parameter
(→  106).
Define output behavior in
alarm condition.
• Actual value
• Defined value
• 0 Hz
–
Failure frequency The Frequency option is
selected in the Operating
mode parameter (→  102)
and a process variable is
selected in the Assign
frequency output parameter
(→  106).
Enter frequency output value
in alarm condition.
0.0 to 12 500.0 Hz –
Invert output signal – Invert the output signal. • No
• Yes
–
* Visibility depends on order options or device settings