Endress+Hauser Proline Promass E 300 - Page 194

Diagnostics and troubleshooting Proline Promass E 300 PROFINET
194 Endress+Hauser
Diagnostic information Remedy instructions
No. Short text
442 Frequency output 1 to n 1. Check process
2. Check frequency output settings
Measured variable status [from the factory]
1)
Quality Good
Quality substatus Ok
Coding (hex) 0x80 to 0x83
Status signal S
Diagnostic behavior Warning
Influenced measured variables
–
1) Diagnostic behavior can be changed. This causes the overall status of the measured variable to change.
Diagnostic information Remedy instructions
No. Short text
443 Pulse output 1 to n 1. Check process
2. Check pulse output settings
Measured variable status [from the factory]
1)
Quality Good
Quality substatus Ok
Coding (hex) 0x80 to 0x83
Status signal S
Diagnostic behavior Warning
Influenced measured variables
–
1) Diagnostic behavior can be changed. This causes the overall status of the measured variable to change.
Diagnostic information Remedy instructions
No. Short text
444 Current input 1 to n 1. Check process
2. Check current input settings
Measured variable status [from the factory]
1)
Quality Good
Quality substatus Ok
Coding (hex) 0x80 to 0x83
Status signal S
Diagnostic behavior Warning
Influenced measured variables
• Measured values 1
• Measured values 2
• Measured values 3
1) Diagnostic behavior can be changed. This causes the overall status of the measured variable to change.