Proline Promass E 300 PROFINET Technical data
Endress+Hauser 253
CE mark The device meets the legal requirements of the applicable EU Directives. These are listed in
the corresponding EU Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
Ex approval The devices are certified for use in hazardous areas and the relevant safety instructions are
provided in the separate "Safety Instructions" (XA) document. Reference is made to this
document on the nameplate.
Sanitary compatibility • 3-A approval
• Only measuring devices with the order code for "Additional approval", option LP "3A"
have 3-A approval.
• The 3-A approval refers to the measuring device.
• When installing the measuring device, ensure that no liquid can accumulate on the
outside of the measuring device.
Remote transmitters must be installed in accordance with the 3-A Standard.
• Accessories (e.g. heating jacket, weather protection cover, wall holder unit) must be
installed in accordance with the 3-A Standard.
Each accessory can be cleaned. Disassembly may be necessary under certain
circumstances.
• EHEDG-tested
Only devices with the order code for "Additional approval", option LT "EHEDG" have been
tested and meet the requirements of the EHEDG.
To meet the requirements for EHEDG certification, the device must be used with process
connections in accordance with the EHEDG position paper entitled "Easy Cleanable Pipe
Couplings and Process Connections" (www.ehedg.org).
• FDA
• Food Contact Materials Regulation (EC) 1935/2004
Pharmaceutical
compatibility
• FDA 21 CFR 177
• USP <87>
• USP <88> Class VI 121 °C
• TSE/BSE Certificate of Suitability
• cGMP
Devices with order code for "Test, certificate", option JG "Compliance with requirements
derived from cGMP, declaration" are in accordance with cGMP requirements relating
to the surfaces of wetted parts, design, FDA 21 CFR material conformity, USP Class VI
tests and TSE/BSE-compliance.
A manufacturer's declaration specific to the serial number is supplied with the device.
Certification PROFINET PROFINET interface
The measuring device is certified and registered by the PNO (PROFIBUS User
Organization). The measuring system meets all the requirements of the following
specifications:
• Certified according to:
• Test specification for PROFINET devices
• PROFINET Security Level 2 – Netload Class
• The device can also be operated with certified devices of other manufacturers
(interoperability)
• The device supports PROFINET S2 system redundancy.
To Next Page
Loading...
