Technical data Proline Promass E 300 PROFINET
254 Endress+Hauser
Pressure Equipment
Directive
• With the identification PED/G1/x (x = category) on the sensor nameplate,
Endress+Hauser confirms conformity with the "Essential Safety Requirements" specified
in Appendix I of the Pressure Equipment Directive 2014/68/EU.
• Devices not bearing this marking (PED) are designed and manufactured according to
good engineering practice. They meet the requirements of Article 4 paragraph 3 of the
Pressure Equipment Directive 2014/68/EU. The range of application is indicated in
tables 6 to 9 in Annex II of the Pressure Equipment Directive 2014/68/EU.
Radio approval The measuring device has radio approval.
For detailed information regarding radio approval, see Special Documentation
→ 257
Additional certification CRN approval
Some device versions have CRN approval. A CRN-approved process connection with a CSA
approval must be ordered for a CRN-approved device.
Tests and certificates
• EN10204-3.1 material certificate, parts and sensor housing in contact with medium
• Pressure testing, internal procedure, inspection certificate
• PMI test (XRF), internal procedure, wetted parts, test report
• Compliance with requirements derived from cGMP, Declaration
• EN10204-2.1 confirmation of compliance with the order and EN10204-2.2 test report
Other standards and
guidelines
• EN 60529
Degrees of protection provided by enclosures (IP code)
• IEC/EN 60068-2-6
Environmental influences: Test procedure - Test Fc: vibrate (sinusoidal).
• IEC/EN 60068-2-31
Environmental influences: Test procedure - Test Ec: shocks due to rough handling,
primarily for devices.
• EN 61010-1
Safety requirements for electrical equipment for measurement, control and laboratory
use - general requirements
• IEC/EN 61326
Emission in accordance with Class A requirements. Electromagnetic compatibility (EMC
requirements).
• NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control
equipment
• NAMUR NE 32
Data retention in the event of a power failure in field and control instruments with
microprocessors
• NAMUR NE 43
Standardization of the signal level for the breakdown information of digital transmitters
with analog output signal.
• NAMUR NE 53
Software of field devices and signal-processing devices with digital electronics
• NAMUR NE 80
The application of the pressure equipment directive to process control devices
• NAMUR NE 105
Specifications for integrating fieldbus devices in engineering tools for field devices
• NAMUR NE 107
Self-monitoring and diagnosis of field devices
• NAMUR NE 131
Requirements for field devices for standard applications
To Next Page
Loading...
