Endress+Hauser Proline Prowirl 73 - Page 135

Proline Prowirl 73 Description of device functions
Endress+Hauser 135
SIMULATION SWITCH
POINT
Prerequisite
The function is only available if STATUS was selected in the OPERATION MODE
function (ä 122).
Description
Use this function to activate simulation of the status output. The notice message #641
"SIMULATION STATUS OUTPUT" (ä 67) indicates that simulation is active. The
measuring device continues to measure while simulation is in progress i.e. the current
measured values are output correctly via the other outputs.
!
Note!
The setting is not saved if the power supply fails.
Options
OFF
ON
Factory setting
OFF
VALUE SIMULATION
SWITCH POINT
Prerequisite
The function is only available if ON was selected in the SIMULATION SWITCH POINT
function (ä 135).
Description
Use this function to specify the status output switching behavior during the simulation.
This value is used to test downstream devices and the measuring device itself. You can
change the switching behavior of the status output during the simulation.
Procedure
• The prompt "CONDUCTIVE" or "NOT CONDUCTIVE" appears if the
O
or
S
key is
pressed. Select the desired switching behavior and start the simulation with the
F
key.
•If the
F
key is pressed again afterwards, the prompt "End simulation" (NO/YES)
appears.
• If you choose "NO", simulation remains active and the group selection is called up.
The simulation can be switched off again via the SIMULATION SWITCH POINT
function.
• If you choose "YES", you end the simulation and the group selection is called up.
!
Note!
The setting is not saved if the power supply fails.
User input
NOT CONDUCTIVE
CONDUCTIVE
Factory setting
NOT CONDUCTIVE
Function description, PULSE, FREQUENCY, STATUS group