Enertech EAV060 - Page 85

Enertech Global 
EAV - EME/EMD Rev. A Models
Installaon and Operaons Manual

Under sengs, scroll down to Domesc Hot Water (aer
entering passcode).
•  Electric immersion heat is used
under high demand situaons. Immersion heat is engaged
aer adjustable Aux HW Delay seng.
•  Compressor only hot water, no
electric immersion heat is used (not recommended).
3.1.1 Before Code 3.1.2 Before Code 3.1.0 Advanced Passcode
3.2.0 3.2.1 Heat Curve 3.3.0
3.4.1 Heat Min Temp 3.4.2 Heat Max Temp 3.4.3 Cool Setpoint
3.1.1 After Code (note: le name is 3.1.0.BMP) 3.1.1 Aux Heat Delay
3.3.1 Heat Setpoint 3.4.0
3.5.0 3.5.1 Aux HW Delay

3.6.0 3.6.1 Hot Water Setpoint 3.6.2 Hot Water Deadband
3.7.2 Load Pump Max Speed 3.7.3 Delta Temp Heat Setpoint 3.7.4 Deta Temp Cool Setpoint
3.8.1 Pressure Units 3.8.2 Replace Filter 3.9.0
3.7.0 3.7.1 Load Pump Min Speed
3.7.5 Temp Units 3.8.0
3.9.0.1 3.9.0.2
• See Indoor Climate.
• Target tank temperature for DHW
operaon.
•  Temperature dierence from
setpoint to minimum temperature the tank can drop to
before heat pump is engaged.