Enertech EAV060 - Outdoor Reset

Enertech Global 
EAV - EME/EMD Rev. A Models
Installaon and Operaons Manual

3.1.1 Before Code 3.1.2 Before Code 3.1.0 Advanced Passcode
3.2.0 3.2.1 Heat Curve 3.3.0
3.4.1 Heat Min Temp 3.4.2 Heat Max Temp 3.4.3 Cool Setpoint
3.1.1 After Code (note: le name is 3.1.0.BMP) 3.1.1 Aux Heat Delay
3.3.1 Heat Setpoint 3.4.0
3.5.0 3.5.1 Aux HW Delay
•  If ON, a call for DHW will take priority
over heang or cooling calls.
•  If ON, a call for Heat will take priority over
cooling.
•  If ON, the leaving uid temperature to
the hydronic heang system will increase as the outdoor
temperature gets colder and will decrease as the outdoor
temperature gets warmer. This mode is recommended for
radiant oor systems for best eciency.
•  If Outdoor Reset is on, the control will use the
heat curve selected (see Figure 21).
3.1.1 Before Code 3.1.2 Before Code 3.1.0 Advanced Passcode
3.2.0 3.2.1 Heat Curve 3.3.0
3.4.1 Heat Min Temp 3.4.2 Heat Max Temp 3.4.3 Cool Setpoint
3.1.1 After Code (note: le name is 3.1.0.BMP) 3.1.1 Aux Heat Delay
3.3.1 Heat Setpoint 3.4.0
3.5.0 3.5.1 Aux HW Delay
• Temperature the system will target if
Outdoor Reset is OFF.
• Maximum temperature allowed in
heang mode is used to ensure ooring manufacturer’s
specicaons for radiant heang. Minimum temperature
is used if Outdoor Reset is Enabled. Note: High Heang
(HHEAT call) setpoint is always set to 120°F leaving uid
temperature.
• Leaving uid temperature used when cooling
call is received (Default 45°F, minimum allowable 42°F).