Enertech EAV060 - Page 83

Enertech Global 
EAV - EME/EMD Rev. A Models
Installaon and Operaons Manual

Under sengs, scroll down to Indoor Climate (aer entering
passcode).
•  Electric immersion
heat is used under high load condions (aer compressor
runs at maximum RPMs for an adjustable period of me)
• Electric immersion heat is not used (not
recommended)
3.1.1 Before Code 3.1.2 Before Code 3.1.0 Advanced Passcode
3.2.0 3.2.1 Heat Curve 3.3.0
3.4.1 Heat Min Temp 3.4.2 Heat Max Temp 3.4.3 Cool Setpoint
3.1.1 After Code (note: le name is 3.1.0.BMP) 3.1.1 Aux Heat Delay
3.3.1 Heat Setpoint 3.4.0
3.5.0 3.5.1 Aux HW Delay

3.1.1 Before Code 3.1.2 Before Code 3.1.0 Advanced Passcode
3.2.0 3.2.1 Heat Curve 3.3.0
3.4.1 Heat Min Temp 3.4.2 Heat Max Temp 3.4.3 Cool Setpoint
3.1.1 After Code (note: le name is 3.1.0.BMP) 3.1.1 Aux Heat Delay
3.3.1 Heat Setpoint 3.4.0
3.5.0 3.5.1 Aux HW Delay
•  Adjust the amount of me the unit must
run full speed before the electric immersion heat is engaged
(Heat Economy mode = OFF)