EnGenius EOC?5610 - Client Bridge Operating Mode; Client Bridge Login

Long Range Wireless Access Point / Client Bridge Version 1.0
28

5 ClientBridgeOperatingMode

5.1 LoggingIn
 To configure the device through the web‐browser, enter the IP  address of the
device(default:192.168.1.1)intotheaddressbaroftheweb‐browserandpress
Enter.
 Make sure that the device and your computer s are configured on the same
subnet.RefertoChapter2inorder
toconfiguretheIPaddressofyourcomputer.
 AfterconnectingtotheIPaddress,theweb‐browserwilldisplaytheloginpage.
 Specifyadminforboththeusernameandpassword.



 After logging in you will graphical user interface (GUI) of the device. The
navigationdrop‐downmenuonleftisdividedintofoursections:
1. Status:Displaystheoverallstatus,connectionstatus,andeventlog.
2. System: This menu include s the system properties, IP and Spanning Tree
settings.

3. Wireless:Thismenuincludesstatus,basic,advanced,andsecurity.
4. Management: This menu includes the adminsetup,SNMP,firmware upgrade,
andsave/restorebackup.
