Enotec COMTEC 6000 - Software Overview and Explanations; 4.1 Software Overview - SYS-MENU; System Information and Calibration Results

Software Overview and Explanations Installation and Operation Manual - COMTEC
®
6000
22 Doc.-ID: COM6000_11022020_EN
4 Software Overview and Explanations
4.1 Software Overview - SYS-MENU
SYS-MENU
System Information
Actual measured values
O
2
measured value (% O
2
) {may be ppm}
O
2
-mA output 17A/B (mA)
O
2
sensor input (mV)
CO
e
measured value (ppm or mg/m
3
)
CO
e
mA output (mA)
CO
e
sensor input (mV)
Flow rate reference air (l/h)
O
2
probe temperature (°C / °F)
O
2
probe heater power (%)
Thermocouple input (mV)
CO
e
sensor temperature
CO
e
heater power (mW)
CO
e
heater resistance (Ω)
CO
e
heater voltage (mV)
CO
e
heater current (mA)
Terminal temperature (°C / °F)
Internal temperature (°C / °F)
O
2
sensor life (%)
Calibration results
e.g. 2012-04-20 (Choose date/time)
Executed at
Calibration method
O
2
sensor calibration
CO
e
sensor calibration
~~ Calibration results ~~
O
2
value at test air (20,95 % O
2
)
♦ calibrated to (% O
2
)
O
2
value at test gas (% O
2
)
♦ calibrated to (% O
2
)
CO
e
value at test air (0 ppm COe)
♦ calibrated to
CO
e
value at test gas (ppm COe)
♦ calibrated to
~~ Calibration data ~~
O
2
sensor offset (mV)
O
2
sensor slope (mV / dec)
CO
e
sensor offset (mV)
CO
e
factor beta