Eon Millennium - Personal Preferences Setup; Music Source Selection; Ringer Adjustment

18
Telephone Operating Instructions
The following items can be programmed at each telephone:
❖ Background music source and volume level.
❖ Ringer volume level and ring type.
❖ Display module contrast.
❖ Handset receiver volume level.
❖ Speaker volume level (handsfree and call announce).
❖ Sidetone level.
To select the background music source and adjust the volume level:
❖ With the handset on-hook, press the MUSIC/MUTE button one or more times to
select music source 1 or 2, or no music.
❖ Press the UP ARROW or DOWN ARROW button to adjust the volume level.
For about 3 seconds after pressing the MENU button, you can use the UP ARROW or
DOWN ARROW button to scroll through the modes. At the end of that time, the telephone
will go into the selected mode for about 10 seconds. Afterward, the display will change
and the telephone will return to its idle state. If the telephone goes into one of the selection
modes, the UP ARROW and DOWN ARROW button indicators will change to ACTIVE
or BUSY, indicating that the buttons can now be used to set the ring level, ring type, or
display contrast. In either of the two ring modes, the ringer will ring.
To set the ringer volume level and ring type:
❖ With the telephone on-hook and idle (even the MUSIC button displays nothing),
press the MENU button.
❖ Within about 3 seconds, if necessary, press the UP ARROW or DOWN ARROW
button one or more times until the message
Mode = ring level select is displayed.
Wait for the UP ARROW and DOWN ARROW button indicators to change to
ACTIVE and for the ringer to ring.
❖ Press the UP ARROW or DOWN ARROW button to increase or decrease the
ringer volume level. When the maximum or minimum volume is reached, the
related button indicator changes to BUSY.
❖ When the ringer volume is satisfactory, press the MENU button or wait for the 10-
second timeout to save the choice and exit the ring level select mode. The ringer
is silenced and the UP ARROW and DOWN ARROW button indicators change to
IDLE.
❖ Press the MENU button again.
❖ Within about 3 seconds, if necessary, press the UP ARROW or DOWN ARROW
button one or more times until the message Mode = ring type select is displayed.
Wait for the UP ARROW and DOWN ARROW button indicators to change to
ACTIVE and for the ringer to ring.
❖ Press the UP ARROW or DOWN ARROW button to change the ring type.
Personal Preferences Setup
Music Source Selection
Ringer Adjustment