29
Telephone Operating Instructions
To set the alarm clock from the telephone where the alarm will ring:
❖ Press the ALARM CLOCK button or dial the Alarm Clock access code. You hear
system dial tone. The SPEAKER button indicator changes to BUSY; if you used
an ALARM CLOCK button, the indicator changes to ACTIVE.
❖ If the system is programmed for a 24-hour clock, dial four digits to set the time. The
first two digits represent the hour, while the second two digits represent the
minutes (for example, 11:15 PM = 2315; 6:45 AM = 0645).
❖ If the system is programmed for a 12-hour clock, dial five digits to set the time. The
first two digits represent the hour, while the second two digits represent the
minutes. The fifth digit is either 1 for AM or 2 for PM (for example, 11:15 AM =
11151; 11:15 PM = 11152).
❖ If your telephone has a display, dial the number (0-9) of the alarm clock message
to be displayed when you hear dial tone. Consult your system administrator for the
text of the alarm clock messages. If your telephone does not have a display, press
the RELEASE or SPEAKER button when you hear dial tone to release your
telephone.
❖ If your telephone has a display, you hear confirmation tone and the ALARM
CLOCK button indicator changes to BUSY. (If you dial an invalid digit, you hear
reorder tone.) Your telephone releases automatically and the SPEAKER button
indicator changes to IDLE.
❖ When the time you set equals that of the system clock, the ALARM CLOCK button
indicator changes to RECALLING and, if applicable, your telephone rings at the
alarm clock ring rate. If your telephone has a display module, the selected
message or message number 0 will be displayed.
❖ Press the ALARM CLOCK button to acknowledge. The ALARM CLOCK button
indicator changes to IDLE. If applicable, ringing stops and the alarm clock
message is cleared from the display.
If you do not answer an alarm clock call within a programmed time, the
ALARM CLOCK button indicator will continue to show RECALLING and the
display will continue to show the alarm clock message but ringing will stop.
To cancel the alarm clock from a telephone with an ALARM CLOCK button, press the
ALARM CLOCK button. The ALARM CLOCK button indicator changes to idle.
To cancel the alarm clock from a telephone without an ALARM CLOCK button:
❖ Dial the local Alarm Clock access code. The alarm is canceled, and after a short
delay, you hear system dial tone over the telephone speaker.
❖ Press the RELEASE button to release.
To set an alarm clock on one or more other telephones from your telephone:
❖ Press the REMOTE ALARM CLOCK SET button or dial the Remote Alarm Clock
access code followed by the digit 1. You hear system dial tone. The SPEAKER
button indicator changes to BUSY; if you use a REMOTE ALARM CLOCK SET
button, the indicator changes to ACTIVE.
Feature Operating Instructions
Alarm Clock
Local
Remote
To Next Page
Loading...