Eon Millennium - Paging; Park to Station

57
Telephone Operating Instructions
To take your telephone out of night transfer mode:
❖ Press the NIGHT ZONE button.
❖ The NIGHT ZONE button indicator changes to IDLE and the programmed night
transfer message is removed from the display.
To page in a specific zone or zones:
❖ Lift the handset.
❖ Press the PAGE button for the zone or zones, or dial the Paging access code,
followed by the digit 0-7 for the specific zone, 8 for zones 0-3, or 9 for zones 4-7.
If you use a PAGE button, the indicator changes to ACTIVE. If applicable, music
is turned off in the selected zone or zones and you hear a warning tone.
❖ When you hear confirmation tone, speak into the handset.
❖ Hang up to release the paging equipment. The PAGE button indicator changes to
IDLE. If applicable, music is turned on in the selected zone or zones.
 1. The paging system can be accessed by only one user at a time. If paging
is not available, you hear busy tone.
2. If you do not finish a page within the programmed time limit, you will be
disconnected and the paging system will be released and made available to
other users.
To page in all zones:
❖ Lift the handset.
❖ Press the ALL PAGE button, or dial the All Page access code, or dial the Paging
access code, followed by ✱. The ALL PAGE button indicator changes to ACTIVE
if a button was used. If applicable, music is turned off in all paging zones and you
hear a warning tone.
❖ When you hear confirmation tone, speak into the handset.
❖ Hang up to release the paging equipment. The ALL PAGE button indicator
changes to IDLE. If applicable, music is turned on in the appropriate zones.
A trunk or station call can be parked to a station. The parked call can be retrieved at the
destination station, or, using Directed Call Pickup, from any other station in the system.
Trunks and stations parked to a station and left unretrieved will recall the parking station
after a programmed timeout interval.
To park a trunk or station call to a station using transfer hold:
❖ Put the call on transfer hold.
❖ When you hear transfer dial tone , press the PARK TO STATION button or dial the
Park To Station access code.
Paging
Park to Station