Eon Millennium - Answer

30
Telephone Operating Instructions
❖ Dial the time as described for Local Alarm Set. If you dial an invalid digit, you hear
reorder tone.
❖ When you hear dial tone again, dial the number (0-9) of the alarm clock message
you want.
❖ When you hear dial tone again, dial the extension number that the alarm will ring.
Listen for dial tone.
❖ Dial any other extension numbers, waiting for dial tone before dialing each one.
As you dial each extension number, the ALARM CLOCK button indicator at the
selected telephone changes to BUSY. If an extension is protected from remote
alarm clock set, you hear reorder tone.
❖ When you have entered the last number, press the RELEASE button or the
SPEAKER button. The SPEAKER button indicator changes to IDLE and, if
applicable, the REMOTE ALARM CLOCK SET button indicator changes to IDLE.
To cancel the remote alarm clock from a telephone with a REMOTE ALARM CLOCK
CANCEL button:
❖ Press the REMOTE ALARM CLOCK CANCEL button or dial the Remote Alarm
Clock access code followed by the digit 0. You hear system dial tone. The
SPEAKER button indicator changes to BUSY; if applicable, the REMOTE ALARM
CLOCK CANCEL button indicator changes to ACTIVE.
❖ Dial the first extension number you are canceling the alarm for.
❖ Dial any other extension numbers, waiting for dial tone before dialing each one.
At each telephone, the ALARM CLOCK button indicator changes to IDLE when the
extension number is dialed.
❖ When you have entered the last number, press the RELEASE button or the
SPEAKER button. The SPEAKER button indicator and, if applicable, the REMOTE
ALARM CLOCK CANCEL button indicator change to idle.
To answer an incoming call from an idle telephone:
❖ Lift the handset.
❖ Press the ANSWER button, or dial the Answer access code. The call is answered.
The button indicator associated with the incoming call changes to ACTIVE.
To answer an incoming call while busy on a call:
❖ Press the ANSWER button, or press the TRANSFER HOLD button and dial the
Answer access code. The current call is put on hold. The incoming call is
answered. The button indicator associated with the call on hold changes to T-
HOLD or I-HOLD. The button indicator associated with the incoming call changes
to ACTIVE.
❖ To return to the call on hold, press the associated button.
Answer