Eon Millennium - Handsfree Operation; Headset;Handset Operation

27
Telephone Operating Instructions
To make an outside call using a trunk route button with the Sender-Receiver option
programmed:
❖ Lift the handset.
❖ Press an idle TRA button. You do not hear CO dial tone. Depending on
programming, you may or may not hear system dial tone.
❖ Dial the outside number, then dial # to indicate the end of dialing, or wait for the
timeout before the system begins to dial the digits.
If a trunk cannot be seized, your telephone is automatically camped on the trunk or trunk
route, and the dialed digits are saved. When a trunk becomes available, your telephone
rings. When you answer, the system dials out the saved digits.
 If the trunk and the system are both programmed for overlap dialing, the called
number will be dialed while you are still dialing. You may or may not hear
dialing, depending on programming.
To call handsfree:
❖ With the handset is on-hook, dial the number you want to call; the speaker and
microphone are enabled when the first digit is dialed. The SPEAKER button
indicator changes to CALLING.
❖ Alternatively, you can press an idle extension or trunk button or the SPEAKER
button and, when you hear system dial tone, dial the number. The associated
button indicator changes to CALLING.
To answer a call handsfree:
❖ Press the SPEAKER button or the calling extension or trunk button when the
telephone rings.
❖ The SPEAKER button indicator changes to BUSY, and the speaker and microphone
are enabled so that you can talk with the caller without lifting the handset.
To adjust the speaker volume, press the UP ARROW and DOWN ARROW buttons during
a call.
To turn off the microphone while on a handsfree call, press the MUSIC/MUTE button. With
the microphone disabled, the distant party cannot hear conversation near the telephone.
You can hear the distant party, but the distant party cannot hear you. To resume 2-way
communication with the distant party, press the MUSIC/MUTE button again.
To transfer a call from handsfree to the handset, lift the handset. The SPEAKER button
indicator changes to IDLE and the microphone and speaker are disabled. You can talk
into the handset.
To transfer a call in progress from the handset to handsfree, first press the SPEAKER
button, then place the handset in the cradle.
To hang up when talking handsfree, press the SPEAKER button.
Digital telephones can be programmed for headset operation, or can be put in the
headset operating mode by pressing the HEADSET/HANDSET button. When the button
is pressed, the associated indicator changes to BUSY.
Handsfree Operation
Headset/Handset Operation