Eon Millennium - Button Change; Call Announce

32
Telephone Operating Instructions
❖ Dial a prime extension number. If the telephone with the prime appearance of the
extension number is on-hook, all appearances of the extension number ring as
usual. If the telephone is off-hook on another button, the BUSY PRIME button
indicator changes to ATTENTION; the system returns busy tone. There is no
indication of the call at any prime or nonprime appearances.
❖ You can transfer the call or cancel the call attempt and return to the call on hold.
● To transfer the call, press the BUSY PRIME button and then press the
RELEASE button or hang up. The call is automatically transferred, the target
telephone receives second call indication and any other appearances of the
called number will ring.
● To cancel the call and return to the party on hold, press the button associated
with the call on hold.
To access a feature programmed on a logical button:
❖ Lift the handset.
❖ Press the BUTTON CHANGE button, or dial the Button Change access code.
❖ When you hear system dial tone, dial the button number for the feature to be
accessed.
 The button number must be within the range specified by the telephone's
location programming. For example, on a telephone programmed as a TYPE
MET18, only buttons 01 through 18 will be recognized. Button 0 and buttons
19 and up would not be recognized.
A single-line telephone user can flash the hookswitch to put a call on hold then dial the
button change code to select a CANCEL button. This is useful in an interactive voice
response (IVR) system to set up a conference between several parties, then, based on
input from the parties, drop them from the conference by pressing the CANCEL button.
Call announce uses tone and voice signaling on internal calls instead of the usual ringing
and allows the called party to reply without picking up the handset. If a telephone cannot
be call-announced for any reason, the call is handled as a normal station-to-station call.
All appearances ring as usual, and you hear ringback tone.
A telephone that has a CALL ANNOUNCE button will remain in the call announce
operating mode until the access code is dialed or the button is pressed a second time.
A telephone that does not have a CALL ANNOUNCE button will automatically return to
the normal operating mode when a call announce call is completed.
To put your telephone in the call announce mode:
❖ Press the CALL ANNOUNCE button or dial the Call Announce access code. The
CALL ANNOUNCE and SPEAKER button indicators change to BUSY. If you use
the dial access code, the EXT button indicator changes to ACTIVE.
 You can put your telephone in the call announce mode only if it is programmed
for it and it has a CALL ANNOUNCE button.
Button Change
Call Announce