Eon Millennium - General Remote Call Pickup; Problem Circuit Tagging; Remote Call Pickup; Ring Again

62
Telephone Operating Instructions
The Problem Tagging access code is used to mark a location that is suspected of failure.
Use of the code is not restricted and can be dialed from any station.
To tag a problem location:
❖ Press the TRANSFER HOLD button to put the station or trunk on hold. The
TRANSFER HOLD button indicator changes to ACTIVE; the button indicator
associated with the held call changes to T-HOLD.
❖ When you hear transfer dial tone, dial the Problem Tagging access code. You hear
confirmation tone. The TRANSFER HOLD button indicator changes to IDLE.
❖ Hang up.
A call to a telephone that is a member of a remote call pickup group can be answered from
any telephone by using an assigned REMOTE CALL PICKUP button or by dialing the
assigned dial access code. The answering telephone may or may not be a member of the
same group.
To answer a call ringing in a remote call pickup group:
❖ Lift the handset.
❖ Press the REMOTE CALL PICKUP button, or dial the Remote Call Pickup access
code plus the number (0-63) of the desired zone. The REMOTE CALL PICKUP
button indicator changes to ACTIVE. The call is transferred to the answering
station. You hear confirmation tone, if programmed.
 If a group has more than one call ringing in, the system selects the first call
to be answered.
General remote call pickup is a dial-accessed feature that allows calls to a remote call
pickup group to be answered from any telephone by dialing a common dial access code.
Depending on programming, the same code may access different remote call pickup
groups when dialed from different telephones.
To answer a call ringing in a remote call pickup group using general remote call pickup:
❖ Lift the handset.
❖ Dial the Remote Call Pickup access code, plus ✱.
❖ The call is transferred to your telephone. You hear confirmation tone, if programmed.
Ring again allows a station user to save the last outside number dialed so that it does not
get overwritten when another outside number is dialed. The saved number can then be
redialed at any time.
To save the last number dialed, press the RERING button while still active on the call or
after going on hook. The RERING button indicator briefly changes to ACTIVE to confirm
that the number has been saved.
Problem Circuit Tagging
Remote Call Pickup
General Remote Call
Pickup
Ring Again