52
Telephone Operating Instructions
To originate a hot line call:
❖ Lift the handset.
❖ Press the HOT LINE button. You hear ringback tone; the HOT LINE button
indicator changes to ACTIVE. All telephones in the intercom network ring at the
programmed ring rate.
❖ When the call is answered, the HOT LINE button indicator continues to indicate
ACTIVE.
To answer a hot line call:
❖ Lift the handset.
❖ Press the calling HOT LINE button. A communication path is established. The
HOT LINE button indicator changes to ACTIVE. At all other appearances, the HOT
LINE button indicator changes to BUSY.
To redial the the last outside number dialed:
❖ Lift the handset.
❖ Press the REDIAL button, or dial the Last Number Redial access code. The
indicator for the REDIAL button briefly displays the ACTIVE symbol while the
stored number is being dialed.
To make a least cost routing (LCR) call:
❖ Lift the handset.
❖ Press the LCR button, or dial the LCR access code. You may or may not hear
system dial tone. The LCR button indicator changes to ACTIVE.
❖ Dial the destination number or the system repertory number for the destination.
Depending on system programming, you may or may not hear dialing sounds.
❖ You hear ringback tone until the called party answers.
1.If LCR is not allowed, you hear reorder tone; if LCR is allowed but all the
required resources are not available, you hear queue tone.
2.Repertory numbers may include LCR access codes, in which case LCR is
automatically accessed when you access the repertory number.
To set LCR special day type:
❖ Lift the handset.
❖ Press the LCR SPECIAL DAY button and dial 1, or dial the LCR Special Day
access code plus 1. You hear system dial tone. The LCR SPECIAL DAY button
indicator changes to ACTIVE.
Last Number Redial
Least Cost Routing
LCR Special Day
Hot Line
To Next Page
Loading...