c
While holding down the [Menu] button, turn on the main power
switch.
When the projector's indicators turn on as follows, release
the [Menu] button.
Power supply Status Laser Temp
Blue - On Blue - On Orange - On Orange - On
The projector is recognized as a removable disk by the computer.
d
Copy the batch setup file (PJCONFDATA.bin) that you saved to
your computer to the top level folder of the removable disk.
a
Do not copy any files or folders other than the batch setup file
to the removable disk.
e
Perform "Remove USB device" on your computer, and then
disconnect the USB cable.
a
When using OS X, perform "Remove EPSON_PJ".
When all of the indicators start flashing, the settings are being
written.
Caution
Do not disconnect the power cord from the projector or turn off the
main power switch while the settings are being written. If power is not
being supplied, the projector may not startup correctly.
When writing completes normally, the projector enters standby
status.
Batch Setup
144
To Next Page
Loading...
Need help?
General