Check Remedy
Is the image brightness adjusted correctly? Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.119
Are the cables connected correctly? Check that all the cables required for projection are securely connected.
Check that no cables are disconnected and that there are no poor contacts in the cables.
s
"Connecting Equipment" p.42
Is the
Contrast
g
adjusted correctly? Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.119
Is the color adjustment set correctly? Adjust the Gamma or RGBCMY setting from the Configuration menu.
s Image - Advanced p.119
s
"Adjusting the Image" p.73
Are the color saturation and tint adjusted correctly? Adjust the Color Saturation and Tint settings from the Configuration menu.
s Image - Color Saturation, Tint p.119
Is the brightness of the room appropriate? If the room is darker than when the auto adjustment was performed, the tint of the projected images may not be displayed
correctly. Make the room darker and then perform auto adjustment again.
s "Screen Matching" p.92
s "Color Calibration" p.182
Images appear dark
Check Remedy
Is the image brightness set correctly? Check the Brightness and Brightness Settings values from the Configuration menu.
s Image - Brightness p.119
s Settings - Brightness Settings p.123
Is the
Contrast
g
adjusted correctly? Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.119
Is only one projector being used? Check if the following item is set to dark.
s Extended - Multi-Projection - Screen Matching - Brightness Settings p.125
Problem Solving
168
To Next Page
Loading...
Need help?
General