To Next Page

To Previous Page

Automatic adjustments are not performed correctly

Check Remedy

Have at least 20 minutes passed since the power was turned on? Auto adjustment does not work correctly until the temperature of the projector is stable. Perform auto adjustment 20

minutes after turning on the projector or canceling Shutter.

Is the cover of the built-in camera clean? Make sure that the cover of the built-in camera is clean. Clean the cover if it is dirty.

Is an analog signal being input? When inputting an analog signal, the color and brightness of the input image changes, and the results of adjustment may

not be applied correctly.

Has the image been corrected using Geometry Correction? Auto adjustment may not work for images corrected using Geometry Correction. Set Geometry Correction to Off or

reduce the correction range.

s Settings - Geometry Correction p.123

Is the brightness of the surroundings appropriate? If a powerful spotlight or natural light shines into the area during auto adjustment, the brightness of the surroundings

changes and auto adjustment does not operate correctly. Make sure the brightness of the surroundings does not change.

Is the blending width 15 to 45%? If the blending width in Edge Blending is 15% or less, or 45% or more, the Screen Matching function may not operate

correctly. Check the blending width.

s Extended - Multi-Projection - Edge Blending p.125

Problems when Projection Starts

The projector does not turn on

Check Remedy

Is the main power switch set to Off? Turn on the main power switch to supply power to the projector.

Did you press the [

] button on the remote control or control

panel?

Press the [ ] button to turn on the power.