When the projector's indicators turn on as follows, release the [Esc]
button.
Power supply Status Laser Temp
Blue - On Blue - On Orange - On Orange - On
The projector is recognized as a removable disk by the computer.
d
Open the removable disk, and save the batch setup file
(PJCONFDATA.bin) to the computer.
a
If you need to change the name of the batch setup file, add text
after PJCONFDATA. If you change the file name, the projector
may not be able to recognize the file correctly.
e
Perform "Remove USB device" on your computer, and then
disconnect the USB cable.
a
When using OS X, perform "Remove EPSON_PJ".
The projector enters standby status.
Reflecting saved settings to other projectors
a
Turn off the main power switch while the power cord is connected
to the projector, and check that all of the projector's indicators
turn off.
b
Connect the computer's USB port to the projector's Service port
with a USB cable.
Batch Setup
143
To Next Page
Loading...
Need help?
General