To Next Page

To Previous Page

Images are fuzzy, out of focus, or distorted

Check Remedy

Is the focus adjusted correctly? Make sure that at least 20 minutes has passed after the projection starts, and press the [Focus] button on the remote

control to adjust the focus.

s "Correcting the Focus" p.34

Is the projector at the correct distance? Is it projecting outside of the recommended projection distance range?

Setup within the recommended range.

s "Screen Size and Projection Distance" p.206

Has condensation formed on the lens? If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient temperature

changes occur, condensation may form on the surface of the lens, and this may cause the images to appear fuzzy. Set the

projector up in the room about one hour before it is used. If condensation forms on the lens, turn the projector off and

wait for the condensation to disappear.

Interference or distortion appear in images

Check Remedy

Are the cables connected correctly? Check that all the cables required for projection are securely connected.

s "Connecting Equipment" p.42

Is an extension cable being used? If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the projector to

check if the cables you are using may be causing the problem.

Is the correct resolution selected?

(Only when projecting computer images)

Set the computer so that the signals being output are compatible with the projector.

s "Supported Monitor Displays" p.217

s Computer's documentation

Are the

Sync.

and Tracking

settings adjusted correctly?

(Only when projecting computer images)

Press the [Auto] button on the Remote Control or the [