Epson EH-TW5300 User Manual

Preparing
15
Installing
Projected Image and Position of Projector
Install the projector as follows.
Installing in parallel with the screen
If the projector is installed at an angle to the screen, keystone distortion occurs in the projected image.
Adjust the projector's position so that it is installed in parallel with the screen.
c
If you cannot install the projector parallel to the screen, correct keystone distortion using the
horizontal keystone adjuster or H/V-Keystone correction.
s p.30
Installing the projector horizontally by adjusting the height of either side
If the projector is tilted, the projected image is also tilted.
Install the projector horizontally so that both sides are at the same height.
If the projector cannot be installed horizontally, you can adjust the projector's tilt with the rear foot.
s p.30

Epson EH-TW5300 Specifications

General

Contrast Ratio	35, 000:1
Projection Technology	3LCD
Weight	3.5 kg
Resolution	1920x1080 (Full HD)
Keystone Correction	Vertical ±30 degrees
Inputs	2 x HDMI, 1 x VGA, 1 x USB Type A, 1 x USB Type B
Speaker	5W
Throw Ratio	1.22 - 1.47
Projection Size	34 inches - 328 inches
Brightness	2, 200 lumens