Basic Operations
26
Projecting Images
Turning On the Projector
a
Connect the equipment to the
projector.
b
Connect using the power cord
supplied.
The projector's power indicator turns blue.
This indicates that the projector is receiving
power, but is not yet turned on (it is in
standby mode).
c
Open the lens cover.
d
Turn on the connected equipment.
e
Press the button on the remote
control or the control panel.
Remote control Control panel
The operation indicator flashes blue as the
projector warms up. Once the projector is
warmed up, the operation indicator stops
flashing and turns blue.
c
When Direct Power On is set to
On, you can start projecting by
simply connecting the power cord
to the projector without having to
press any buttons.
s
Extended -
Operation - Direct Power
On p.70
Warning
•
Do not look into the lens during projection. The
powerful light emitted could cause damage to
eyesight.
•
Do not stand in front of the lens during projection.
Clothes could be damaged due to the high
temperature.
c
•
This projector provides a Child Lock function to prevent children from accidentally turning the power
on and a Control Panel Lock function to prevent accidental operations and so on.
s Settings - Lock
Setting - Child Lock/Control Panel Lock p.68
•
This projector provides an Auto Setup function to automatically select the optimum settings when the
input signal for the connected computer image changes.
s Signal - Auto Setup p.66
•
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s Extended - Operation -
High Altitude Mode p.70
If the target image is not projected
If the image is not projected, you can change the source using one of the following methods.
To Next Page
Loading...
Need help?
General
