EasyManuals Logo

Epson EH-TW5300 User Manual

Epson EH-TW5300
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #93 background imageLoading...
Page #93 background image
Maintenance
92
Replacing Consumables
Replacing the air filter
c
Dispose of used air filters properly in accordance with your local regulations.
Filter frame: ABS
Filter: Polyurethane foam
a
Press the button on the remote
control or the control panel to turn off
the power, and then disconnect the
power cord.
b
Open the air filter cover.
c
Remove the old air filter.
Grip the air filter cover tab and pull it
straight up.
d
Install the new air filter.
Slide in the air filter until it clicks into place.
e
Close the air filter cover.
Replacing the lamp
Warning
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be
broken. If replacing the lamp of a projector that has been suspended from the ceiling, you should always
assume that the lamp is cracked, and remove the lamp cover with care. When you open the lamp cover,
small shards of glass could fall out. If any shards of glass get into your eyes or mouth, contact a doctor
immediately.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EH-TW5300 and is the answer not in the manual?

Epson EH-TW5300 Specifications

General IconGeneral
Contrast Ratio35, 000:1
Projection Technology3LCD
Weight3.5 kg
Resolution1920x1080 (Full HD)
Keystone CorrectionVertical ±30 degrees
Inputs2 x HDMI, 1 x VGA, 1 x USB Type A, 1 x USB Type B
Speaker5W
Throw Ratio1.22 - 1.47
Projection Size34 inches - 328 inches
Brightness2, 200 lumens

Related product manuals