Epson EH-TW5300 User Manual

Maintenance
93
Caution
•
Do not touch the lamp cover immediately after turning off the projector as it is still hot. Wait until the lamp
has cooled down sufficiently before removing the lamp cover. Otherwise, you could get burnt.
•
We recommend the use of genuine EPSON option lamps. The use of non-genuine lamps may affect projection
quality and safety.
Any damage or malfunction caused by the use of non-genuine lamps may not be covered by Epson's warranty.
a
Press the button on the remote
control or the control panel to turn off
the power, and then disconnect the
power cord.
b
Loosen the lamp cover fixing screw.
c
Remove the lamp cover.
Slide the lamp cover straight forward and
remove it.
d
Loosen the two lamp fixing screws.
e
Remove the old lamp.
Grip the projection and pull it straight out.
f
Install the new lamp.
Make sure the lamp is facing the correct
direction and press it in.
g
Tighten the two lamp fixing screws.

Epson EH-TW5300 Specifications

General

Contrast Ratio	35, 000:1
Projection Technology	3LCD
Weight	3.5 kg
Resolution	1920x1080 (Full HD)
Keystone Correction	Vertical ±30 degrees
Inputs	2 x HDMI, 1 x VGA, 1 x USB Type A, 1 x USB Type B
Speaker	5W
Throw Ratio	1.22 - 1.47
Projection Size	34 inches - 328 inches
Brightness	2, 200 lumens