Adjusting the Image
39
Viewing the Image at the Saved Image Quality
(Memory Function)
Saving a Memory
You can save the adjustment values for Image from the Configuration menu.
a
Press the button, and then make
the settings for Image that you want
to save.
b
Press the button.
c
Use the buttons to
select Save Memory, and then press
the
button to confirm the
selection.
d
Use the buttons to
select the memory name to be saved,
and then press the
button to
confirm the selection.
The current projector settings are saved to
the memory.
If the mark on the left of the memory name
is turned aqua, it means the memory has
already been registered. When you select a
registered memory, a message is displayed
asking you to confirm that you want to
overwrite the memory. If you select Yes, the
previous content is erased and the current
settings are saved.
Loading a Memory
You can load saved adjustment values from the remote control to change the image quality.
a
Press the button, and then select Load Memory.
The Load Memory screen is displayed.
b
Select the target memory name.
c
•
The color mode saved to the memory is displayed on the right.
•
Depending on the input signal, part of the loaded memory item may not be applied to the
projected image.
•
Memories saved for 2D images can only be loaded when projecting 2D images. Memories saved
for 3D images can only be loaded when projecting 3D images.
To Next Page
Loading...
Need help?
General
