Basic Operations
30
c
It becomes more difficult to focus the higher the tilt angle is. Use a moderate tilt angle.
Adjusting the Projector's Tilt
If the projected image is horizontally tilted (the left and right sides of the projected image are at different
heights) when the projector is setup on a table, adjust the rear foot so that both sides are level with each other.
Correcting Distortion
You can correct keystone distortion using one of the following methods.
Correct automatically
(EH-TW5350/EH-
TW5300 only)
Auto V-Keystone Automatically correct vertical keystone distortion.
Correct manually H-Keystone Adjuster Correct horizontal keystone distortion with the horizontal
keystone adjuster.
H/V-Keystone Manually correct distortion in the horizontal and vertical di-
rections independently.
c
•
The projected image becomes smaller after correcting distortion. Increase the projection distance to
fit the projected image to the screen size.
•
Install the projector parallel with the screen without any loss in image quality. If you cannot install the
projector parallel to the screen, adjust the shape of the image using H/V-Keystone correction.
Correct automatically (Auto V-Keystone) (EH-TW5350/EH-TW5300 only)
When the projector is moved or tilted during projection, Auto V-Keystone automatically corrects any vertical
keystone distortion. Two seconds after the projector is moved, it displays an adjustment screen and then
automatically corrects the projected image.
Auto V-Keystone can correct the projected image distortion in these conditions:
•
Projection angle is less than 30° up or down.
•
Projection is set to Front. s Extended - Projection p.70
To Next Page
Loading...
Need help?
General
