Epson ELPWP20 User Manual

Before using the wireless transmitter, you may need to pair it with the receiver
(bas
e unit or supported projector).
Caution
Do n
ot disconnect the wireless transmitter or the power cord of the base unit
or projector while sending network information. If the power cord or wireless
transmitter is disconnected, pairing may not be performed correctly. Check that
the completion message is displayed before disconnecting the wireless transmitter.
•
Yo
u need to congure the network settings for the base unit or
projector you are using before you perform pairing.
•
If you are using the Wireless Presentation System (ELPWP10) with
a supported projector, see your projector User's Guide for network
settings for the projector.
g
Related Links
•
"R
easons for Pairing" p.21
•
"Pairing Using a Base Unit" p.21
•
"Pairing on a Computer" p.22
•
"Pairing Using a Projector" p.22
•
"Base Unit Indicator Status" p.105
•
"Wireless Transmitter Indicator Status" p.106
Reasons for Pairing
You need to pair the wireless transmitter with the receiver in the following
sit
uations:
•
e rst time you start using the Epson Wireless Presentation System
(ELPWP10) (You are using a supported projector as a receiver)
•
e rst time you start using the optional wireless transmitter (ELPWT01)
•
When changing the receiver being used
•
Wh
en the following settings in the Network Settings have been changed aer
pairing
•
Base Unit Name (If you are using a base unit)
•
Projector Name or Passphrase (If you are using a supported projector)
e wireless transmitter supplied with the Wireless Presentation System
(ELPWP20) i
s paired with the base unit at the time of shipment.
Pairing Using a Base Unit
When adding another wireless transmitter to the wireless presentation system
(ELPWP20), yo
u can pair the wireless transmitter using your base unit.
Steps 1, 2, and 4 are not necessary if you can conr
m that pairing is
complete using the wireless transmitter indicator.
a
Connect the supplied HDMI cable to your external display device's HDMI
inp
ut port.
b
Connect the other end to the base unit's HDMI Out port.
c
Press the power button on the base unit or remote control to turn on the
b
as
e unit.
e status indicator ashes blue as the base unit warms up. Once the base
unit is warmed up, the status indicator stops ashing and remains blue.
d
Turn on the connected external display device.
Pairing the Wireless Transmitter
21

Epson ELPWP20 Specifications

General

Brand	Epson
Model	ELPWP20
Category	Projector Accessories
Language	English