e
Remove the USB conversion adapter on the wireless transmitter and
conn
ect the transmitter to the base unit's USB-A port.
e pairing process starts. e wireless transmitter indicator ashes
al
ternately blue and orange during pairing. When pairing is complete,
the wireless transmitter indicator is lit blue and a completion message is
displayed on the screen if the base unit is connected to an external display
device. e pairing process may take some time to complete.
f
Remove the wireless transmitter from the base unit.
R
ep
eat steps 5 and 6 to perform pairing with any other wireless
transmitters as necessary.
Pairing on a Computer
You can pair the wireless transmitter with the receiver (base unit or supported
pr
ojector) on a computer using the Epson Wireless Transmitter Settings
soware.
You can download and install Epson Wireless Transmitter Settings from the
following Web site.
epson.sn
See the Epson Wireless Transmitter Settings Operation Guide for instructions.
Pairing Using a Projector
When using the Epson Wireless Presentation System (ELPWP10), you can pair
th
e wireless transmitter with a supported projector.
Attention
Dep
ending on the projector model, you may need to update the rmware.
a
Turn on the projector.
b
Remove the USB conversion adapter for the wireless transmitter and
conn
ect the transmitter to the projector's USB-A port.
Network information is automatically written to the wireless transmitter.
e pairing process may take some time to complete.
c
Remove the wireless transmitter from the projector when a completion
mes
sage is displayed on the screen.
Repeat steps 2 and 3 to perform pairing with any other wireless
transmitters as necessary.
Select Yes to set Connection Guide Display to On if necessary.
You need to install the wireless LAN module (ELPAP11) on the projector
bef
ore starting wireless projection.
Pairing the Wireless Transmitter
22
To Next Page
Loading...
Need help?
General
