Epson ELPWP20 - Batch Setup Error Notification

k
When the base unit's indicator turns on, release the [Menu] button.
e com
puter recognizes the base unit as a removable disk.
l
Copy the batch setup le (PJC
ONFDATA.bin) that you saved to your
computer to the top level folder of the removable disk.
Do not copy any les or f
olders other than the batch setup le to the
removable disk.
m
Eject the USB device (Windows) or drag the removable disk icon to the
T
ras
h (Mac).
n
Disconnect the USB cable.
Wh
en the indicator starts ashing, the settings are being written. When
writing is nished, the base unit turns o.
Caution
Do n
ot disconnect the AC adapter from the base unit while the le is being
written. If the AC adapter is disconnected, the base unit may not start
correctly.
g
Related Links
•
"B
atch Setup Error Notication" p.97
Batch Setup Error Notication
e base unit's indicators notify you if an error occurs during a batch
setup operation. Check the status of the base unit's indicator and follow the
instructions described in the table here.
Indicator status Problem and solutions
Flashing orange e batch setup le may be corrupt, or the USB ash
dr
ive or USB cable may not be connected correctly.
Disconnect the USB ash drive or the USB cable, unplug
and then plug in the base unit's power cord, and then try
again.
If the problem persists, unplug the base unit and contact
Epson for help.
Copying Menu Settings Between Base Units (Batch Setup)
97