a
Enter the password using the numeric buttons.
e password screen closes.
b
If the password is incorrect, you see a message and a prompt to try again.
Ent
er the correct password to proceed.
Attention
•
If an in
correct password is entered three times in succession, the message
e base unit's operation will be locked. is displayed for approximately
5 minutes, and the base unit switches to standby mode. If this happens,
disconnect the power plug from the electrical outlet, reinsert it, and turn
the base unit back on. e base unit displays the password entry screen
again so that you can enter the correct password.
•
If you have forgotten the password, make a note of the " Request Code:
xxxxx" number that appears on the screen and contact Epson for help.
•
If you continue to repeat the above operation and input the wrong
password 30 times in succession, the message e base unit's operation
will be locked. Contact Epson as described in your documentation. is
displayed and the base unit does not accept any more password entries.
Contact Epson for help.
Installing a Security Cable
You can use the security slot on the base unit to attach a Kensington Microsaver
Se
curity system as a the deterrent.
For more details on the Microsaver Security System, see ht
tp://
www.kensington.com/.
Base Unit Security Features
68
To Next Page
Loading...
Need help?
General
