Settings item Settings value Explanation
Top/Bottom Mar‐
gins
Standard
*
Setting this to Standard will set the top/bottom margins as follows
depending on the printer driver print targets.
❏ CAD/Line Drawing: 3 mm/3 mm
❏ Other: 30 mm/30 mm
Left and right margins will remain at 3 mm regardless of settings. If
there is any soiling to the top section of the print results, then try
increasing the top margin before printing.
U “Printable area” on page 163
Top 3 mm/Bottom 3 mm
Top 15 mm/Bottom 15
mm
Top 45 mm/Bottom 15
mm
Back Tension
Auto
*
If there is any wrinkling on the paper during printing, select High
or Extra High.
Standard
High
Extra High
Drying Time
Drying Time per
Pass
0.0 to 10.0 seconds (0.0
*
)
Select the time the print head pauses to allow drying after each
pass. Choose from values between 0.0 and 10.0 seconds.
Depending on the paper type, the ink may take a while to dry. If
the ink blurs on the paper, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
Drying Time per
Page
0.0 to 60 minutes (0.0
*
)
Specify how long the printer pauses to allow the ink to dry after
printing each page; choose from values between 0 and 60 minutes.
Depending on the ink density or paper type, the ink may take a
while to dry. If the ink blurs on the paper, set a longer time for
drying the ink. The longer the drying time, the more time required
for printing.
Auto Cut
On
*
Choose On to automatically cut roll paper using the built-in cutter
as each page is printed or O to disable auto paper cutting. Setting
this to On also automatically cuts the leading edge if the edge is
not a horizontal cut when the roll paper is loaded.
The setting selected with the printer driver takes priority when the
printer driver is used.
U “Cutting the Roll Paper” on page 30
O
Restore Default Restore the selected Custom Paper settings to default settings.
Printing Language
USB
Auto
*
Normally, leave the setting as Auto. If HP-GL/2 or HP RTL print data
is sent from a CAD application or plotter, this is automatically
determined, and switched to HP-GL/2 mode.
If HP-GL/2 mode printing is not carried out normally, or if normally
printing in HP-GL/2 or HP RTL, set as HP-GL/2.
HP-GL/2
Network
Auto
*
HP-GL/2
SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series User's Guide
Using the Menu
119
To Next Page
Loading...
