Your software is not properly
set up for your printer.
Make sure that your printer is
properly selected in your software.
Install or reinstall the printer software
as described in Chapter 2.
Nothing prints and the control panel lights are on or flashing.
Cause What to do
Several common printer
errors have occured at once.
Use the table in “Error indicators”
earlier in this chapter to determine
what combination of errors may have
occurred, and apply the recommended
solutions.
The printer sounds like it is printing, but nothing prints.
Cause What to do
The print head nozzles are
clogged.
Clean the print head. See “Cleaning
the Print Head” later in this chapter.
If this does not work after four or five
trials, see below.
One or both of the ink
cartridges have been used
longer than six months or
beyond the date on the
packaging.
Try cleaning the print head. If that
does not solve the problem, replace
the ink cartridges as needed. If the
B
and
A
ink out lights are off, see page
8-30 to replace the ink cartridge.
8
Troubleshooting
R
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 8
05-29-97 DR, pass 0
Troubleshooting
8-9
To Next Page
Loading...
