The paper is old or creased. Use only new, smooth sheets of paper.
The paper’s size is not
compatible with the printer.
Use paper that meets the paper
requirements for this printer. See
“Paper” in Appendix C.
The printer loads more than one sheet at a time.
Cause What to do
Too many sheets are loaded
in the sheet feeder.
Take the paper stack out of the feeder,
remove some sheets, and reload paper.
Before you load paper, check the
amount of paper you can load in the
sheet feeder. See Chapter 6.
The edge guides are not set
correctly.
Adjust the guides against the stack of
paper. See “Loading Paper” in
Chapter 3.
The paper is too thin. Make sure the paper meets the paper
requirements for this printer. See
“Paper” in Appendix C.
Ejected paper is wrinkled.
Cause What to do
The paper is damp. Do not store your paper in a damp or
humid environment. Store paper in its
original packaging.
The paper is too thin. Make sure the paper meets the paper
requirements for this printer. See
“Paper” in Appendix C.
8
Troubleshooting
R
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 8
05-29-97 DR, pass 0
Troubleshooting
8-15
To Next Page
Loading...
