Paper does not fully eject.
Cause What to do
The paper is too long. Press the
E
load/eject button to eject
the paper. Use paper that meets the
paper requirements for this printer.
See “Paper” in Appendix C.
Paper feed or paper jam problems occur frequently.
Cause What to do
Sheets of paper are stuck
together.
Fan the stack of paper and align the
edges before loading.
The paper is too thin or
rough.
Make sure the paper meets the paper
requirements for this printer. See
“Paper” in Appendix C.
Too many sheets are loaded
in the sheet feeder.
Check the paper package and
Chapter 6, “Printing on Special Paper”,
for the amount of paper you can load
at one time in the sheet feeder .
The printable side of the
paper is not correctly loaded.
Try turning the stack of paper over in
the sheet feeder. Most packages of
paper indicate the printable side with
an arrow on the end of the package.
Make sure the printable side is loaded
face up.
L
Fiji2 Ref. Guide
Rev.b
A5 size Chapter 8
05-29-97 DR, pass 0
8-16
Troubleshooting
To Next Page
Loading...
