Stylus Pro 4880 Field Repair Guide 1/17/08
980mm Feed Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 136.
980mm Feed Adjustment
Note: The 980mm Feed Adjustment calibrates the Paper Feed Mechanism.
1. Load 17” Enhanced Matte roll paper.
2. From the Adjustment Wizard for the Pro 4880, select the 1000mm Feed Adjustment.
1. Click on the Print button.
2. The Printer will print the 1000mm alignment patter
6. Click the Finish button.
3. Align a 1000mm ruler with the center vertical hash
marks, and the leading edge horizontal line (see
the Red Line on the example graphic). The “0” end
of the 1000mm ruler should be touching, but not
covering the leading edge horizontal line.
5. Click on the Write button.
6. Enter the value that was measured.
4. Use a lens to align the 1000mm ruler exactly with
the horizontal and vertical lines.
5. Using a lens, measure the exact distance between
the 2 horizontal lines. Be as accurate as possible
To Next Page
Loading...
