Stylus Pro 4880 Field Repair Guide 1/17/08
Auto Uni-D Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 138.
Auto Uni-D Adjustment
Note: This adjustment automatically performs all Uni-Directional Adjustments.
1. Load 17” Enhanced Matte roll paper.
2. From the Adjustment Wizard for the Pro 4880, select the Auto Uni-D Adjustment.
1. Click on the Run button.
2. The Printer will print out these patterns. It will
take approximately 12 minutes
4. Click the Finish button.
3. The Printer will read the alignment patterns
automatically (using the Multi Sensor), and
write the appropriate values to the board.
To Next Page
Loading...
