Stylus Pro 4880 Field Repair Guide 1/17/08
Auto Bi-D Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 137.
Auto Bi-D Adjustment
Note: This adjustment automatically performs all Bi-Directional Adjustments.
1. Load 17” Enhanced Matte roll paper.
2. From the Adjustment Wizard for the Pro 4880, select the Auto Bi-D Adjustment.
1. Click on the Run button.
2. The Printer will print out these patterns. It will
take approximately 12 minutes
4. Click the Finish button.
3. The Printer will read the alignment patterns
automatically (using the Multi Sensor), and
write the appropriate values to the board.
To Next Page
Loading...
